GWTCH 急冷急熱模溫機

WMCH rapid cool and heat mold temperature controller

型        號 ： GWTCH
Model: GWTCH

類        型  ： 注塑行業
Type: Plastic injection industry

>>應用范圍     顯示器、家電、空調、光學、車燈、通訊等產品之精密快速射出成型
Application range:Use high-pressure high -volume pump ,heating ,cooling rapidly ,with rapid injection molding. 

●   配合射出機信號，根據系統注塑成型工藝要求輸出熱水或冰水(冷卻水)
With signal injection machine, injection molding process in accordance with system requirements of the output hot water or cold water(cooling water) to ensure the injection mold, when in touch all the good flow of plastic to eliminate air bubbles
●   模溫機熱水使用溫度140℃/180℃
2.The highest mold temperature the machines used hot water temperature max. 140℃/180℃
●   采用大流量泵浦，升溫、降溫迅速,配合快速成型射出
Use high-pressure high-volume pump, heating, cooling rapidly, with rapid injection molding
●   具備模具回水功能、有效縮小熱能量損耗、省電、縮短成型周期
Have the function of water recovery, hot water energy recovering efficiently, water saving, shortening the molding cycle
●   注塑產品無結合線、無流痕、無氣泡、不用噴涂二次加工、降低制造成本
No bonded line on high-lighted surface of injecttion product, no flow marks, no bubbles, no secondary processing of spraying, lower manufacturing costs
●   小投資，單機搞定，不用鍋爐等大投資
Small investment to get stand-alone, not big investment as the boiler

●總電源過電流無熔絲斷路器Circuit breaker       
●異常警報蜂鳴器Alarm sounding
●馬達反轉保護及指示燈Oil lack protective lamp           
●出水壓力表 Water output pressure gauge
●冷卻水缺水保護及指示燈Cooling water less protective lamp         
●過熱保護溫度開關Overheat protective lamp
●循環泵浦過載保護及指示燈Circuiting pump overload protective lamp       
●回水溫度顯示表Water return temp. display
●By-Pass泄壓回路   By-pass pressure release circuit             
●電源欠相保護Power protection